The Device Management section shows an overview of information about all the devices in a group or organization.
Several changes can be made to multiple devices at the same time after selecting these devices.
This section is available in Organization Settings>Device Management and Group Settings>Device Management.
Device Management at Organizational Level allows you to view the details of all your devices in your organization; at Group Level the details of devices in the group are shown.
The following options are available:
Configure the columns showing details of your devices
Click to Add devices
Status
Device Name
Serial Number
Group
Tags
Product
Uptime
Online Status
Wan
2.4 GHz Channel
5 GHz Channel
Usage
Clients
Firmware
Last Config Applied
InControl Detected IP
The Column order can be changed by keeping a column selected with your mouse and by dragging it to the desired position.
Select the required options and click OK to save the settings or Reset the Default Order.
The order of the devices in view can be changed by selecting the required column.
The device names of Selected Devices are shown in the top bar in the overview of the device management section.
Tags can be added to the selected devices or an action can be applied to the selected devices.
The InControl Detected IP in the equally named column is not always the WAN IP address of your Peplink Router. It could be the NAT-ted WAN IP address of the broadband connection depending on your network configuration.
Add or remove Tags and icons to or from the selected devices by selecting the Tags button.
Icons can be used as tags as well and be added to one or more units.
Several actions are available by selecting the actions drop down bar.
Options that are not available for the selected devices (because they apply to different Peplink devices not in the group) are Greyed Out.
The following options can be configured from this view:
| Action | Description |
| Move to | Move devices to a different group |
| Remove | Remove devices from the organization |
| Firmware | Apply a firmware policy |
| Find My Peplink | Configure the Peplink DDNS service |
| Wi-Fi AP State | View the Wi-Fi status of Access Points |
| AP Routing Mode | View Access Point routing mode status |
| Enable DPI | Enable Deep Packet inspection |
| DHCP Snooping | Configure DHCP snooping for Peplink switches |
| STP Bridge priority | Configure STP Bridge priority for Peplink switches |
| Enable collecting Wi-Fi analytics data | Enable collecting Wi-Fi analytics data |
| Lock cellular WANs to currently active SIM Cards | Lock cellular WANs to currently active SIM Cards |
| Remove GPS Data | Remove GPS Data |
| Data Roaming | Configure Data Roaming |
| Update cellular module firmware | Update cellular module firmware |